Log Placement - Lsu24Spf - Empire Comfort Systems MILLIVOLT DVCP36SP30N-1 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare
hands! Always wear gloves to prevent skin irritation. After
handling logs, wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean
operation of this fireplace. Sooting and other problems may result
if the logs are not properly and firmly positioned in the fireplace.
Refer to Figure 66 for the following warning.
Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved
with this fireplace may result in property damage or
personal injury.
Attention: Do not use Figure 66 to order replacement logs. Refer
to Page 38 Log Identification to order logs for your appropriate
model number
NOTICE: Once the installation is complete with the glowing
embers and log set in place, operate the fireplace to verify flame
appearance. If there are flames directly impinging a log, turn
off fireplace, then remove the glowing ember material directly
below where the flame impingement occurred. This should
eliminate sooting on the log, and provide a more pleasing flame
appearance.
Replacement of glowing embers must be purchased from an
Empire Comfort Systems Dealer. Application of excess glowing
embers may adversely affect performance of the fireplace.
All previously applied loose material must be removed
prior to reapplication.
1
6
13
Burner Pin and Tab Identification - Figure 68
36092-10-0619

LOG PLACEMENT - LSU24SPF

WARNING
WARNING
2
3
8
9
10
7
14
15
Log Placement Figure 66
FRONT VIEW - COMPLETED LOG SET INSTALLATION
(WITHOUT EMBERS)
4
5
11
12
16
17
Figure 67
Page 39