External Device Link Settings - Panasonic TH-86EQ2W Operating Instructions Manual

External device link settings

Sets external device link.
[External device link settings]- submenu screen
External device link settings
Device information
Wireless presentation link
Webex link
■
[Device information]
Sets whether to display or hide the information of
the device connected to the HDMI terminal or SLOT
terminal.
[Off]: Connected device information is not
displayed.
[On]: Connected device information is displayed as
shown below.
HDMI1
Player1
Note
●
The obtained information of either signal or
HDMICEC is displayed.
●
Up to the first 16 characters obtained are
displayed.
■
Wireless presentation link
This menu configures the settings for wireless
presentation system connection.
For details, refer to the operating instructions on the
following support site.
(https://panasonic.net/cns/prodisplays/wps2/)
■
[Webex link]
Sets the link of a Webex device.
[Off]:
Does not link with a Webex device.
[On]:
Links with a Webex device.
Note
● When a Webex device is connected to the HDMI IN
1, HDMI IN 2 or HDMI IN 3 terminal, the link function
works.
● The following functions are fixed.
[Video conference mode settings] of the
•
corresponding input is fixed to [On].
For details of operation when [Video conference
mode settings] is set to [On], refer to [Video
conference mode settings] (see page 71).
[Picture mode] is set to the suitable value.
•
[Over scan] is fixed to [Off].
•
64
English
Off
On
On
16:9
[HDMI-CEC control] is fixed to [Enable]. [Display
•
→ Device] is fixed to [Power off / on]. [Device →
Display] is fixed to [Power off / on].
[Quick start] is fixed to [On].
•
[Audio input select] is fixed to the corresponding
•
input.
[HDMI-CEC control] is set to [Enable].
•
When another device is connected to an HDMI
terminal other than the HDMI terminal to which
a Webex device is connected, if the HDMI-CEC
control is unnecessary, turn off the HDMI-CEC
function using that device.
When the link operation is in progress with a
•
Webex device connected, [Webex] is displayed on
the setup menu, etc.
Due to the specification of a Webex device, the
•
Webex device cannot be set to standby mode by
turning off (standby) the power of the display. (As
of April 2022)