Table of Contents
Advertisement
Names of Parts
Operation Panel
1
2
4
3
1
2
3
4
5
6
7
8
9
10 Error Indicator — This indicator flashes red when an error has occurred. In this case, check
11 System Menu/Counter Key and Indicator — Press this key to light the indicator to perform
12 Keypad — Use these keys to set the number of copies to be made or enter other values. You
13 Reset/Power Key — Press this key to reset all temporary configurations previously made. The
2-4
5
6
7
8
15
17
19
16
18
Status/Job Cancel Key and Indicator — Press this key to light the indicator to access the
Status menu screen. For details, refer to Chapter 4 in Advanced Operation Guide.
Copy Key and Indicator — Press this key to use the copier functions of this machine. The
indicator will light when the machine is in the copier operation mode.
E-Mail (Scan) Key and Indicator — Press this key to use the scanner functions of this
machine. The indicator will light when the machine is in the scanner operation mode.
One-touch Keys (1 to 8) — The one-touch keys can be used to register destination
information. For details, refer to Chapter 5, Advanced Operation Guide, Registering
Destination E-mail Address. Enter the information for the registered destinations onto the
supplied one-touch key sheet and insert the sheet between the one-touch keys from the bottom
side of the operation panel.
Scan Color Select Key and Indicator — Press this key to light the indicator to change the
Scan Color mode. For details, refer to Chapter 2 in Advanced Operation Guide, Selecting
Scan Color Mode.
Scan Resolution Key and Indicator — Press this key to light the indicator to change the scan
resolution. For details, refer to Chapter 2 in Advanced Operation Guide, Selecting the
Scanning Resolution.
Function Key and Indicator — Press this key to light the indicator to access the Function
screen.
Print Indicator — This indicator flashes green when the machine is processing a printing job.
Send/Receive Indicator — This indicator flashes green when the machine is sending or
receiving data.
the message display and perform the appropriate procedure to correct the error. See page 7-3.
This indicator lights red when the machine is experiencing a mechanical problem. Turn the
power switch off ( ) and then back on ( | ) again. If the Error indication does not go out, make
a note of the message that appears in the message display.
default settings, change the language on the display, etc. (For details, refer to Chapter 5 in
Advanced Operation Guide.)
can also use these keys to enter characters.
machine returns to the initial mode
the sleep mode. To release the machine from the sleep mode, press the same key again. (See
page 4-12.)
9
10
Ready to copy.
*
Set
: 1
A 4
A 4
100%
Zoom
20
21
23
22
†
. Press down on this key for at least two seconds to engage
11
12
24
27
26
25
13
14
28
29
Advertisement
Table of Contents
