Service And Maintenance - Festool Vecturo OS 400 EQ Original Operating Manual

GB OS 400 EQ
Attaching the positioning aid - [7A] or [7B].
WARNING
Sharp tools
Pinching and cutting injuries
Always rest your fingers on the defined gripping
surfaces [8-2].
Always use the saw blades indicated in Fig. [8] !
Do not use short saw blades!
10

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
To ensure constant air circulation, always keep the
cooling air openings in the motor housing clean and
free of blockages.
The machine is equipped with special carbon
brushes. If they are worn, the power is interrupted
automatically and the machine comes to a stand-
still.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
14
a hazard, have them replaced by an authorised
after-sales service workshop.
Information on the positioning aid
Clean any dust deposits from guides [8-1]! Oil the
guides regularly and lightly with resin-free oil (e.g.
sewing machine oil).
11 Environment
Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
12 EU Declaration of Conformity
Oscillator
OS 400 EQ
Year of CE mark: 2013
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following Directives, standards and normative
documents:
2006/42/EG, 2004/108/EG, 2011/65/EU, EN 60745-
1, EN 60745-2-11, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
2013-11-28
Serial no.
499693, 500185, 499695