Service And Maintenance - Festool Carvex PSC 400 EB Original Operating Manual/Spare Parts List

CARVEX
GB
Freely guided sawing along a scribe mark
The triangular shape of the splinterguard
points to the cutting line of the saw blade. This
facilitates sawing along a scribe mark.
8.1 Lighting
WARNING
The stroboscope light may make it diffi-
cult to determine the saw blade position
Risk of injury
X
Ensure the work area is well illuminated.
A continuous light or stroboscope is installed for
illuminating the cutting line:
up to approx. 2100 rpm: continuous light
from approx. 2100 rpm: stroboscope light
L In overhead position (+/- 45°), the lighting
is switched off completely.
If required, you can adjust the lighting:
X
Press both buttons simultaneously [1-2] and
hold for approx. 10 s until a beep sounds.
X
Release both buttons [1-2].
X Press the left button (on the pendulum
stroke side) to select the required mode:
Mode Display during
configuration
1 Light flashes
2 Light on
3 Light off
X
Press the right button to save the setting.
8.2 Acoustic warning signal
Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
peep ― ―
– Battery flat or machine overloaded.
X
Change the battery.
X
Place the machine under reduced stress.
peep peep ―
– Machine is overheating.
X
You must allow the machine to cool before
using again.
peep peep peep
20
[5-1]
Performance dur-
ing operation
with stroboscope
(standard)
Permanent light
without stroboscope
Light switched off
– LiIon battery pack is faulty or has overheated.
X Once the battery pack has cooled, perform a
functional check using the charger.
9

Service and maintenance

WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack from the
machine before any maintenance or care work!
X All maintenance and repair work which re-
quires the motor housing to be opened,
must only be carried out by an authorised
service workshop.
Damaged safety devices and components must
be repaired or replaced in a recognised special-
ist workshop, unless otherwise indicated in the
operating manual.
Observe the following instructions:
– Keep the air slits on the machine and the
charger free and clean to ensure adequate
cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
– Check the guidance roller regularly for wear.
– Regularly remove dust deposits from the chip
guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
Information on battery packs
– Where possible, store the battery pack in a
cool, dry place at a temperature between
5 °C and 25 °C.
– Battery packs are most efficient at tempera-
tures between 20 °C and 30 °C.
– Protect the battery pack from moisture, wa-
ter and heat.
– Significantly shorter operating times after
each charge indicate that the battery pack is
worn and should be replaced with a new one.
– The LiIon battery pack is fully compatible
with the charger! Integrated electronics pre-
vent overloading and overheating during the
charging process.
– Do not leave flat battery packs in a charger
disconnected from the mains power supply
for longer than one month. There is a risk of
total discharge and the maximum power of
the battery pack may decrease.
– Store the battery pack in its packaging to re-
duce the risk of short circuits..