Safety Features; System Lock/Safety Lock - Miele SmartLine Tepan Yaki Operating And Installation Instructions

Hide thumbs Also See for SmartLine Tepan Yaki:
Table of Contents

Advertisement

System lock/safety lock

The safety lock function is
deactivated if there is a mains
outage.
Your SmartLine element is equipped
with a system lock and a safety lock to
prevent the element from being
switched on or any settings being
altered by mistake.
The system lock is activated when the
SmartLine element is switched off. If
the system lock is activated, the
element cannot be switched on and the
timer cannot be used. A set minute
minder time continues to count down.
The SmartLine element is programmed
so that the system lock must be
activated manually. It can be
programmed to be activated
automatically 5 minutes after the
SmartLine element has been switched
off (see "Programming").
The safety lock is activated when the
SmartLine element is switched on.
When the safety lock is activated, the
element can be operated only under
certain conditions:
- Selected power levels cannot be
changed.
- A set minute minder time can be
modified.
- The SmartLine element can only be
switched off.
If an unavailable sensor control is
touched whilst the system lock or
safety lock is activated  will appear
in the timer display for a few seconds
and a tone will sound.
Activating the system lock
 Touch the  sensor for 6 seconds.
The seconds can be seen counting
down in the timer display. When this
time has elapsed  will appear in the
timer display. The system lock has been
activated.
Deactivating the system lock
 Touch the  sensor for 6 seconds.
 will appear briefly in the timer
display and then the seconds will be
seen counting down. The system lock is
deactivated once the time has elapsed.
Activating the safety lock
 Touch and hold the  and 
sensors at the same time for
6 seconds.
The seconds can be seen counting
down in the timer display. When this
time has elapsed  will appear in the
timer display. The safety lock is
activated.
Deactivating the safety lock
 Touch and hold the  and 
sensors at the same time for
6 seconds.
 will appear briefly in the timer
display and then the seconds will be
seen counting down. Once the time has
elapsed, the lock function is
deactivated.

Safety features

31

Advertisement

Table of Contents
loading

Table of Contents