Table of Contents
Advertisement
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Messages in the display
Issue
After the SmartLine
element has been
switched on or a sensor
control has been
touched, appears in
the timer display for a
few seconds.
After the SmartLine
element has been
switched on appears
in the timer display for a
short while. The
SmartLine element
does not heat up.
The SmartLine element
has switched off
automatically. When the
element is switched
back on, appears
above the On/Off
sensor control .
flashes alternately
with in the timer
display and a tone will
sound.
will flash alternately
with in the timer
display.
Cause and remedy
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"System lock / Safety lock").
The SmartLine element is in demonstration mode.
Touch the 0 and 2 sensor controls at the same
time until flashes alternately with in the
timer display.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
Clean off any dirt and/or remove the object (see
"Safety features" – "Safety switch-off").
The SmartLine element is connected incorrectly.
Disconnect the SmartLine element from the mains.
Contact your Miele dealer.
The overheating protection mechanism has been
activated.
See "Safety features – Overheating protection".
Problem solving guide
39
Advertisement
Table of Contents
