Setting The Signal - Siemens WD14H490AU Instruction Manual And Installation Instructions

M

Setting the signal

S e t t i n g t h e s i g n a l
1. Activate setting mode for the signal volume
Turn to $ Off.
2.a Set the volume for the button signals (depending on model)
Touch the Start delay button until the
required volume is reached
2.b Selecting the volume for the information signals
Turn one position clockwise.
Turn one position Press and hold Temp.°C button
clockwise. + turn one position clockwise.
Go to step 2.b or Set to $ Off, swhich exits setting mode for
Touch the Start delay button
until the required volume is
reached.
Setting the signal
Release the button, figure
apperas in the display.
the signal volume.
Set to $ Off, which exits setting
mode for the signal volume.
en
27