Table of Contents
Advertisement
15.
Swing the rear of the drive pedal shaft support
bracket down.
16.
Disconnect the steering gear box from the main
shaft by removing the hair pin clip.
See Figure 5B.53
Hair pin clip
Figure 5B.53
17.
Disconnect the reverse switch.
See Figure 5B.54
Reverse switch.
Figure 5B.54
18.
Drop the left side of the main shaft out of slot.
19.
Slide the main shaft out of the tractor.
Steering gearbox
arm
45
To install the drive shaft assemblies:
1.
Install the middle hex bushing.
See Figure 5B.55
Figure 5B.55
2.
Slide the right side of the main shaft through the
middle hex bushing. See Figure 5B.55
3.
Connect the reverse switch.
4.
Connect the steering gearbox:
4a. Slide the hole in the bell crank on the main
shaft over the pin on the steering gearbox
lever. See Figure 5B.56
Hair pin clip
Bell crank
Figure 5B.56
4b. Install the hair pin clip. See Figure 5B.56
DRIVE SYSTEM-IVT
Middle hex bushing
Steering gearbox
lever
Advertisement
Table of Contents
