Table of Contents
Advertisement
Faults and what to do about them.
en
Information on the display panel
Display
YES
NO
NO flashes
F:16
F:17
F:18
F:21
F:23
E
N flashes
26
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
■
door immediately, if necessary. Select Start/Reload to continue the pro-
gramme.
Wait until YES + ¼ light up.
■
Note: Do not open the washing machine door until both the symbols YES + ¼
■
light up.
Close the washing machine door properly; washing may be trapped.
Turn the water tap on fully,
■
Supply hose kinked or trapped,
■
Water pressure too low. Clean the filter. ~ Page 25
■
Detergent solution pump blocked. Clean the detergent solution pump.
■
~ Page 23
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
■
~ Page 24
Motor fault. Call the after-sales service. ~ Page 28
Water in the base trough, appliance leaking. Call the after-sales service.
~ Page 28
Childproof lock activated; deactivate it. ~ Page 19
Too much foam detected, a rinse cycle has been switched on ~ Page 20
Advertisement
Table of Contents
