Table of Contents
Advertisement
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse / Spin / Empty).
Press the Start/Reload button. Allow
3.
the programme to run for
approximately 40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Remove the filter using pliers and
clean the filter.
Connect the hose and check for
7.
leaks.
Faults and what to do about them.
3
Faults and what to do
about them.
Emergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m .
E.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is rotating.
Do not reach into the drum while it is
rotating.
Wait until the drum has stopped
rotating.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Switch off the appliance. Pull out the
1.
mains plug.
Drain off the detergent solution
2.
~ Page 23
Use a tool to pull the emergency
3.
release downwards and release it.
The washing machine door can then
be opened.
en
25
Advertisement
Table of Contents
