Information On The Display Panel; Faults And What To Do About Them - Bosch WAK20200GB Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Information on the display panel

Display
YES
NO
¼ flashes
E:17
E:18
E:23
E
9 flashes
:
.
Other displays

Faults and what to do about them.

Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature falls.
Water level too high. Not possible to add laundry. If necessary, close the wash-
ing machine door immediately. To continue the programme, press Start/
Reload.
Laundry may be caught. Please open and close the washing machine door
again and press Start/Reload.
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Turn the water tap on fully,
The supply hose is kinked/trapped,
The water pressure is too low. Clean the filter. ~ Page 25
The detergent solution pump is blocked. Clean the detergent solution pump.
~ Page 24
The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.
Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales
service.
The childproof lock is activated; to deactivate: ~ Page 20
Too much foam detected, a rinse cycle has been switched on.
The mains voltage is too low.
Undervoltage in the wash programme.
The programme is extended. ~ Page 21
Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service.
Cause/remedial action
Attach/replace the drainage hose correctly.
Tighten the screw connection of the supply hose.
Start/Reload not pressed?
Tap not turned on?
Filter blocked? Clean the filter. ~ Page 25
Supply hose kinked or trapped?
Safety function active. Programme stopped?
– – – 0 (Rinse hold = without final spin) selected?
Can be opened by emergency release only? ~ Page 26
Faults and what to do about them.
en
27

Advertisement

Table of Contents
loading

Table of Contents