Faults And What To Do About Them - Bosch WAE20464IL Series Instruction Manual And Installation Instructions

Faults and what to do about them.

Faults
Water is leaking out.
No water supply.
Detergent is not dis-
pensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
The programme duration
is longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the
compartment for care
products.
Odours in the washing
machine.
The N symbol flashes in
the display panel. Foam
may escape from the
detergent drawer.
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter. ~ Page 25
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped? ~ Page 20
■
$ (without final spin) selected?
■
Can be opened by emergency release only? ~ Page 25
■
Start/Reload or Finished in -time selected?
■
Washing machine door closed?
■
E Childproof lock activated? Deactivate. ~ Page 19
■
$ (without final spin) selected?
■
Clean the detergent solution pump. ~ Page 23
■
Clean the waste pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Reduced Ironing selected?
■
Selected speed too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is active – adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may lead to changes in the programme duration in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary ~ Page 23
■
Run the Cottons 90 °C programme without laundry.
Use standard detergent.
Too much detergent used?
Mix one tablespoon of fabric softener with 1/2 litre water and pour into com-
partment II (not for outdoor fabrics or those made with down).
Reduce the detergent dosage for the next wash cycle.
Faults and what to do about them.
en
27