The Drain Hose At The Siphon Is Blocked - Bosch WAE20464IL Series Instruction Manual And Installation Instructions

Cleaning and maintenance
en
4. For models with a drain hose:
Take the drain hose out of the
retainer.
Remove the sealing cap; allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drain hose in the retainer.
5. For models without a drain hose:
Carefully unscrew the pump cover
until the detergent solution begins to
flow out.
When the service flap is half full,
close the pump cover and drain the
service flap.
Repeat the above steps until all the
detergent solution has completely
drained out.
Carefully unscrew the pump cover;
6.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
24
Place the service flap back on, lock
7.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Empty programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection point using the hose
clamp.