Table of Contents
Advertisement
Cleaning and maintenance
en
Take the auxilary drain hose out of
4.
the holder.
Remove the locking cap and drain
off the water into a suitable
container.
Replace the locking cap and place
the drain hose back in the holder.
Carefully unscrew the pump cover;
5.
remaining water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit and screw on the pump cover.
The handle must be in a vertical
position.
38
Put the service flap back on, engage
6.
and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into the left-hand compartment
and start the programme Drain.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Advertisement
Table of Contents
