Table of Contents
Advertisement
The drain hose at the siphon
is blocked
Turn the programme selector to Off.
1.
Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select the Cottons (activate G
2.
SpeedPerfect setting) programme.
If your appliance with
Note:
intelligent dosing system
need to deactivate the intelligent
dosing system.
Select the Start/Pause A button.
3.
Allow the programme to run for
approx. 40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
5.
*
Depending on the module
Clean the filters:
1.
2.
3.
*
, you also
4.
Cleaning and maintenance
Disconnect the hose from the rear of
the appliance.
Use pliers to remove the filter.
Clean the filter with a small brush.
Connect the hose and check for
leaks.
en
41
Advertisement
Table of Contents
