HP Visualize b160L Supplementary Manual page 139

Chap5.doc 117 Thu Jul 25 10:24:29 1996
NOTICE:
Grasp the EGRAM module from the sides and pull
2
it straight up to disconnect it from the CPU board
connector
, as shown in Figure 41.
When replacing the EGRAM module make sure
that its connector is correctly aligned with the
connector on the CPU board and press down firmly
to make sure that it is fully connected. Press down
on the corners of the module to make sure that the
standoffs are fully engaged.
If you are moving the EGRAM module to a new
CPU board assembly, from the underside of the
CPU board assembly use a pair of needle-nose
pliers to squeeze the tabs on the standoffs and push
them out of the CPU board. Transfer the standoffs
to the new CPU board.
Field Replaceable Units
FRU Removal and Replacement
117