HP Vectra XU5 Getting Started Manual page 16

Setting User Preferences (including User Password)
The SETUP program allows you to view and set your PC's configuration. Use the PC's
SETUP program to set a User Password, set the Keyboard Lock Timer, and enable Screen
Blanking.
The User Password provides:
a User Password prompt to prevent your PC from being started in your absence
a Keyboard Lock Button to lock your PC when you are away from your desk, leaving
your applications running. It also prevents your PC from being reset or turned OFF.
a Keyboard Lock Timer to lock your PC automatically when you haven't used the
keyboard or mouse for a specified time.
Screen Blanking to hide your data when the PC is locked.
NOTE You cannot use Screen Blanking if your PC has a Matrox video adapter board.
Starting the PC's SETUP program:
1. Save your data and exit any program, then press-and-hold the RESET button on the
control panel until the PC restarts.
2. Press [F2] while <Setup=F2 > is displayed at the bottom of the screen.
<Setup=F2 > appears for only a couple of seconds, just after the beeps signaling the
end of the Power-On Self-Test.
If you miss <Setup=F2 >, press-and-hold the RESET button to restart the PC, and try
again.
3. The PC's SETUP program will appear.
HP Vectra XU – Getting Started Preparing Your PC for Use 16