HP Vectra XU5 Getting Started Manual page 15

Configuring the Matrox Video Adapter Board
To select the video resolution, we recommend that you use only the HP User Tools or the
MGA Control Panel. To use the MGA Control Panel, double-click on the MGA Control Panel
icon in the bottom left-hand corner of your display. (On models without a hard disk, the video
board can be configured using the Matrox configuration utility supplied on diskette.)
Configure the Matrox video board, using the HP User Tools in Windows as follows:
1. Double-click on the HP User Tools icon, in the HP Utils Group in Windows.
2. Click on the Video Mode button and a dialog box appears.
3. Click on the Graphics button, and follow the instructions on the screen.
Adjust the display screen's brightness and contrast to your needs. If the picture does not fill
the screen or is not centered, adjust the position of the screen image. Set the keyboard to a
comfortable position.
To optimize conventional memory:
Exit from Windows. Run MemMaker from the MS-DOS prompt and follow the instructions on
the screen. This MS-DOS utility optimizes your PC's memory, increasing the amount of
conventional memory available to your applications.
Your PC installation is complete.
Before using your PC, set a User Password and enable Screen Blanking, as described in
the next section.
HP Vectra XU – Getting Started Preparing Your PC for Use 15