Table of Contents
Advertisement
Power-on System Hardware Tests
When the PC is switched on or reset, a power-on hardware test is performed. IF an error
code appears, press enter to view a short explanation of the meaning of the error.
0130, 0241, 0280
What you should do:
1.
Ensure the configuration stored in CMOS has not been cleared by the system board jumper (refer to
chapter 5).
2.
Run SETUP to correct the configuration information
3.
Replace the battery if the configuration is repeatedly lost.
4.
If all of the above fail to correct the problem, the system board may need to be replaced. Contact
your service representative.
0250
What you should do:
1.
Run SETUP and correct the erro rs highlighted by the SETUP program.
2.
Ensure the configuration stored in CMOS has not been cleared by the system board jumper. Make a
written note of the configuration.
3.
If the hardware was changed, run SETUP to update the configuration information.
06xx
What you should do:
1.
Ensure that nothing is pushing down on the keyboard and that no key is stuck down.
2.
If the problem persists, contact your service representative.
61xx, 6500, 6510, 6520, 8x06
What you should do:
1.
Ensure the memory modules are installed correctly (refer to chapter 3).
2.
If this does not fix the problem, initialize the system ROM(refer to "If You Can't Start the SETUP
Program" in this chapter)
3.
If the problem persists, the system board may need to be replaced. Contact your service
representative.
65xx, 66xx
What you should do:
1.
Disable all shadowing in SETUP
2.
If this fails to correct the problem, they system board may need to be replaced. Contact your service
representative.
8xxx
What you should do:
1.
Check that the hard disk drive has not been disabled in SETUP.
2.
Check that the disk power and data cables are correctly connected (refer to chapter 3).
3.
If the hard disk has not been detected, use the custom parameters in SETUP.
910B
HP Vectra XM 5/xx Series PC Familiarization Guide
Repair
54
3 Troubleshooting and
Advertisement
Table of Contents
