HP Vectra XM5 3 Supplementary Manual page 47

Using the ISA Configuration Utility (ICU)
Use the ICU to configure Plug and Play accessory boards if Plug and Play Device
Management is set to None or Boot Only in the SETUP program.
The ICU can also determine the recommended settings for each ISA non-Plug and Play
board. These settings may be different from those recom mended by the accessory board's
manufacturer. In this case, the board's jumper settings and driver options must be altered.
1. Double-click on the Plug and Play group icon in the Windows Program Manager.
2 Double-click on the ICU icon to launch the ISA Configuration Utility and configure system resources
for the accessory board.
The ICU is preloaded with configuration details for many non-Plug and Play accessory boards. If an
accessory board is not listed by the ICU, there are two options:
Some non-Plug and Play accessory boards are supplied with a configuration file, which can be
used by the ICU to determine which resources are required by the board.
If there is not a configuration file for the accessory board, enter the configuration details
manually when prompted by the ICU. Refer to the documentation supplied with the accessory
board for information on the resources required by the board.
HP Vectra XM 5/xx Series PC Familiarization Guide
47
2 PC Hardware Structure