Remote Boot Under Windows Nt Server 4.0; Installation Procedure - HP Vectra VL6 7 Administrator's Manual

5 Configuring for Remote Boot

Remote Boot under Windows NT Server 4.0

Remote Boot under Windows NT Server 4.0
The installation and setting up of the remote boot service is described in the
INSTALL.HLP on-line help file provided by Windows NT Server 4.0.
The procedure below is based on the INSTALL.HLP HELP file, except that step 4
has been added for correct automatic setup of the HP Ethernet Family Adapter so
that you do not have to do the setup described in "Creating Remoteboot
Configurations for New Adapters" in the INSTALL.HLP documentation.

Installation Procedure

To install the remote boot service to boot HP Ethernet Family Adapter clients:
1 Install the remote boot service:
a Select Start, Settings, Control Panel, Network.
b If the DLC protocol isn't already installed, choose the Protocol tab in the
Network dialog box, and
c Choose the Services tab in the Network dialog box, and
remote boot service. Assuming that your NT default directory is
install it in the
\WINNT40\RPL
2 Install MS-DOS files for remote boot workstations:
a Check that the
RPL\RPLFILES
should have the share name RPLFILES.
b Copy all the MS-DOS files, including the system files
to the
RPL\RPLFILES\BINFILES\DOSxxx
number (supported version are 330, 401, 500, 600, 622). The file
should be renamed as
c Remove any attributes such as S, A, H from your system files.
To install Windows for remote boot workstations, refer to the relevant section of
the NT Server 4.0 online installation help.
92 English
to install the DLC protocol.
Add...
directory.
directory is shared on the remoteboot server. It
directory, where xxx is the version
, and
msdos.sys ibmbio.com
to install the
Add...
\WINNT40
and
io.sys msdos.sys
ibmdos.com
as .
io.sys
,
,