Ndis 2.01 Driver For Banyan Vines Client; Installation Procedure - HP Vectra VL6 7 Administrator's Manual

4 Installing Other Network Drivers

NDIS 2.01 Driver for Banyan VINES Client

NDIS 2.01 Driver for Banyan VINES Client
The PCnet driver may be configured to run in the Banyan VINES environment for
client-based systems only.

Installation Procedure

The steps to load the driver are as follows:
1 Compile all the files necessary for VINES. For ease of use, all of these files were
placed in the
C:\NDIS
2 Create PROTOCOL.INI, CONFIG.SYS, and AUTOEXEC.BAT (refer to the
example below).
a Modify the PROTOCOL.INI to reflect the changes necessary for the
appropriate LAN card section.
b Modify the AUTOEXEC.BAT and CONFIG.SYS to reflect changes in the
DIRECTORY of where the files are to be placed.
3 Run the VINES PCCONFIG to configure the NDIS Ethernet Driver:
a Select
Network Card Settings
.
Ethernet
b Verify that the interrupt level matches the one used by the driver (check that
the "bindings" parameter is PCNTND:
bindings = PCNTND
c Save and exit from PCCONFIG.
4 Restart the PC.
5 At the DOS prompt type BAN
The installation is now complete.
62 English
subdirectory.
. Then in the list provided, select
).
NDIS