Remote Boot On Windows Nt; Installation Procedure - HP Vectra VL6 7 Administrator's Manual

5 Configuring for Remote Boot

Remote Boot on Windows NT

Remote Boot on Windows NT
This section explains how to setup the remote boot service on a Windows NT server
to boot client Vectras equipped with an HP Ethernet Family Adapter.
The installation and setting up of the Remote Boot service is described in Windows
NT 3.x online installation help.
The procedure below is based on the INSTALL.HLP HELP file, except that step 4
has been added for the correct automatic setup of the HP Ethernet Family Adapter
so that you do not have to do the setup described in "Creating Remoteboot
Configurations for New Adapters" in the INSTALL.HLP documentation.

Installation Procedure

To install the remote boot service to boot HP Ethernet Family Adapter clients:
1 Install the Remoteboot service:
a In Control Panel, choose the Network icon.
b If the DLC protocol isn't already installed, in the Network settings dialog box,
choose Add Software button, and install the DLC protocol.
c In the Network settings dialog box, choose Add Software button. Select the
Remoteboot Service. Assuming that your NT default directory is
install it in
\WINNT35\RPL
2 To install MS-DOS files for remoteboot workstations:
a Check that the
RPL\RPLFILES
should have the share name RPLFILES.
b Copy all the MS-DOS files, including the system files
to the
RPL\RPLFILES\BINFILES\DOSxxx
number (supported version are 330, 401, 500, 600, 622). The file
should be renamed as
c Remove any attributes such as S, A, H from your system files.
To install Windows for Remoteboot Workstations, refer to the relevant section of
the online installation help.
90 English
directory.
directory is shared on the remoteboot server. It
directory, where xxx is the version
, and
msdos.sys ibmbio.com
\WINNT35
and
io.sys msdos.sys
ibmdos.com
as .
io.sys
,
,