Table of Contents
Advertisement
Decommissioning/
Removal from
Service
NOTE
The decommissioning procedure applies to 640m series PCI PTS version 6.1
POI-approved devices.
Failure to use this decommission procedure causes non-compliance to the PCI
PTS POI Modular Security Requirements version 6.0 approval of the device.
To securely decommission the device:
1
Prepare your tool — a #8 Phillips head screwdriver is necessary.
2
Ensure that the device is disconnected from power and any other cables.
3
Turn the device face down, exposing the rear of the device.
Using the Phillips head screwdriver, remove each of the eight screws. Two of
4
the screws are hidden behind the SIM/SAM Cover, including one covered by
a temper-evident security label.
Push the screwdriver through this label to access the screw.
5
Once all the identified screws have been removed, carefully separate the top
housing plastics from the bottom 1mm, then pinch the top and bottom housing
back together ensuring a proper fit.
6
Reinsert all of the screws previously removed. Tighten each screw completely.
7
Insert the power cable and power up the device.
8
Turn the device face up showing the display and keypad. Verify that the unit is
in an "Active Tamper." You should see the *TAMPER* message displayed on
the screen.
M
C
AINTENANCE AND
LEANING
Additional Safety Information
640
I
G
M
NSTALLATION
UIDE
27
Advertisement
Table of Contents
