HP ProLiant xw25p User Manual page 24

Refer to Figure 13 for the completed direct cabling method using diagnostic cable
(left) and the local I/O cable (right).
Figure 13: Completed direct cabling method (front and
rear views) using the diagnostic cable (1) and the local
I/O cable (2) to connect to iLO
After the direct cabling method is complete, the server blade and diagnostic station
are ready for use. See the "Powering Up the Server Blade" section.
IMPORTANT: Before removing the local I/O cable, completely log out of the current iLO
session. Do not remove the local I/O cable when the Unit Identification (UID) LED is blinking.
Using the Direct Cabling Method with USB Devices
Use the following setup to configure a server blade using a SmartStart CD or to load
software updates and patches using the CD-ROM.
Connect to the server using the direct cabling method with USB devices:
1. Follow steps 1 through 7 of "Using the Direct Cabling Method with a Client PC"
to make connections from the server blade to the Diagnostic Station.
2. Connect the server blade connector on the local I/O cable to the server blade.
24 HP ProLiant BL p-Class System Diagnostic Station User Guide