Table of Contents
Advertisement
●
The display panel cable is available using the following spare part numbers:
●
●
●
o.
Before replacing the display panel assembly, thoroughly clean all adhesive residue from the display
panel assembly before installing new adhesive strips. Remove the protective backing from the new
adhesive strips, align the holes (1) on the strips with the pins (2) on the display panel assembly, and
then attach the strips to the display panel assembly.
12.
If you need to remove the OLED module:
a.
Remove the display assembly.
b.
Remove the display panel assembly.
c.
Release the ZIF connector (1) to which the OLED module cable is connected, and then disconnect the
OLED module cable from the OLED module.
d.
Detach the OLED module from the display panel. (The OLED module is attached to the display panel
with double-sided adhesive.)
The OLED module is available using spare part number N09652-001.
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
N09665-001: In nightfall black finish - 39.6 cm (15.6 in), LCD, FHD (1920 × 1080), white light-
emitting diode WLED, antiglare, UWVA, 45% CG, eDP 1.2 without PSR, VWE, bent, TOP display
panel with narrow bezel; typical brightness: 250 nits
N09650-001: For use on computer models equipped with a display assembly with an OLED
display panel
N09649-001: For use on computer models equipped with a display assembly with an QHD display
panel
N09648-001: For use on computer models equipped with a display assembly with an FHD display
panel
Advertisement
Table of Contents
