Table of Contents
Advertisement
c.
Attach two suction cups (1) to the display assembly as shown in the following illustration.
d.
Secure the suction cups to the display assembly by swinging the handles (2) into position.
When releasing the display panel assembly, be sure not to attach the suction cups to the area near the
webcam/microphone module in the center of the display panel assembly.
e.
The display panel assembly is secured to the display back cover with retention tape that is installed
under the left and right sides of the panel. Use the suction cups (1) and a case utility tool (2) to
carefully separate the display panel assembly from the display back cover until the retention tape tabs
are accessible in the upper left (3) and right corners of the display panel assembly.
When releasing the display panel assembly, be sure not to insert the case utility tool into the area near
the webcam/microphone module in the center of the display panel assembly.
f.
Access the retention tape tabs in the upper left (1) and right corners of the display panel. Use
tweezers to grasp the end of the tape (2). While turning the tweezers, wrap the tape around the
tweezers as you continue to pull the tape out (3) from behind the display panel. You must pull the
tape multiple times before it is completely removed.
Display assembly
47
Advertisement
Table of Contents
