Table of Contents
Advertisement
2.
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then remove
the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1.
Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot at
an angle until it is seated (2).
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
To prevent damage to the memory module, hold the memory module by the edges only. Do
Advertisement
Table of Contents
