Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the studio cycle is used.
Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the studio cycle, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
PEDAL MAINTENANCE
Tighten the pedals weekly using the included studio
cycle tool. Tighten the right pedal clockwise, and
tighten the left pedal counterclockwise.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in and that the power
switch is pressed on.
If a replacement power adapter is needed, see the
back cover of this manual. IMPORTANT: To avoid
damaging the console, use only a manufacturer-
supplied regulated power adapter.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, press the power switch and unplug the
power adapter. Next, locate the small reset opening (A)
on the side or the back of the console. Using a bent
paper clip, press and hold the reset button inside the
opening, and have a second person plug in the power
adapter and press the power switch. Continue holding
the reset button until the console turns on. When the
Note: This drawing is scaled to 94% compared to the
other assembly drawings and to the exploded drawing.
reset operation is complete, the console will turn off
and then turn back on. If it does not, press the power
switch and unplug the power adapter, and then plug it
in again and press the power switch. Once the con-
sole turns on, check for firmware updates (see HOW
TO CHANGE CONSOLE SETTINGS on page 27).
Note: It may take a few minutes for the console to be
ready for use.
HOW TO ADJUST THE CONSOLE PIVOT AND TILT
If the console feels too loose or does not stay in place
when it is moved from side to side, first remove the
Mount Cover (153). Next, use the included studio cycle
tool to tighten the M25 Locknut (152) slightly until the
console stays in place when moved from side to side.
Then, press the Mount Cover back into place.
153
If the console feels too loose or does not stay in
place when it is tilted upward and downward, first
see assembly step 8 on page 11. Use a standard
screwdriver to pry off the Console Covers (154, 155).
Next, tighten the four
M6 x 15mm Cap Screws
(157) in the Rear Bracket
A
Mount (114) until the up
and down movement
no longer feels loose.
Note: For clarity, the con-
sole is not shown in the
drawing. Tilt the console
upward and downward to
access the Cap Screws.
Then, see assembly step 8 on page 11 and reattach
the Console Covers (154, 155).
30
152
157
114
157
Advertisement
Table of Contents
