Table of Contents
Advertisement
vOnboard FDC Controller
This item is used to set whether the onboard FDC controller is enable.
vOnboard Serial Port 1/2
This items are used to assign the I/O address and interrupt request(IRQ) for
the onboard serial port 1/2.These items cannot be adjusted.
vUART Mode Select
Use this item to select the UART mode.Setting values include Normal, IrDA,
ASKIR. The setting value is determined by the infrared module installed on
the board.
vUR 2 Duplex Mode
This item is available when UART Mode Select is set to either ASKIR or IrDA.
This item enables you to determine the infrared function of the onboard infra
red chip.
vOnboard Parallel Port
This item allows you to determine onboard parallel port controller I/O address
and interrupt request(IRQ).
vParallel Port Mode
This item is used to assign data transport protocols of parallel port.The avail
able option: SPP, EPP, ECP, ECP+EPP and Normal. Normal mode supports
data output only; ECP and EPP mode support data input and output in bidirec
tional mode,but they just fit known ECP and EPP devices.
vECP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This
field is configured only if Parallel Port Mode is set to ECP.
38
Chapter 3
Onboard Super IO Device Menu
BIOS Description
Advertisement
Table of Contents
