Connecting An External Scsi Accessory - HP Kayak XA User Manual

ashak.bk : ashak-1.fb4 Page 6 Wednesday, July 15, 1998 6:41 PM
NOTE
NOTE
1 Setting Up and Using Your PC Workstation
Connecting an External SCSI Accessory (Selected Models Only)

Connecting an External SCSI Accessory

(Selected Models Only)
An external SCSI device is connected as follows:
1 You should assign an unused SCSI ID to the accessory. SCSI IDs
range from 0 to 15 for wide 16-bit SCSI. The SCSI ID 0 is reserved for
the first SCSI hard disk drive and SCSI ID 7 is reserved for SCSI
controller (the default for narrow and wide SCSI devices).
You don't need to set a SCSI ID for Plug and Play SCSI devices (SCSI
devices which support the SCAM protocol).
Windows 98 does not support SCAM.
2 Make sure the SCSI accessory is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI accessory).
3 Connect the SCSI accessory to your PC Workstation's external 16-bit
SCSI connector with a shielded SCSI cable.
4 Refer to the manual provided with the SCSI accessory to learn how
to install any software that may be necessary to use it.
The total length of the external SCSI cables should not exceed 3 meters
(approximately 10 feet).
6 English