Crest Audio DM-NAX-8ZSA Quick Start Manual page 8

DM-NAX-8ZSA
DM NAX™ 8-Zone Streaming Amplifier
Spotify Connect™ Setup
The DM-NAX-8ZSA supports Spotify Connect.
To configure Spotify, use your phone, tablet or computer as a remote
control for Spotify. Go to spotify.com/connect
Spotify can be enabled on any of the built-in media players on the DM-
NAX-8ZSA.
To stream media from a device to a speaker zone in your distributed
audio system:
1. Ensure that the device and DM-NAX-8ZSA are on the same network.
2. On the DM-NAX-8ZSA, enable Spotify for the built-in media player
you would like to stream to, either using the web UI or programming.
For more information, refer to the
9045).
NOTE: If the control/media and Audio-over-IP network traffic is
isolated between two network ports on the DM-NAX-8ZSA,
Spotify will use the port specified for the Control/Media traffic.
3. On your device:
a. Enable Spotify
b. From the list of available Spotify destinations, select the DM-
NAX-8ZSA zone you would like to stream to.
The media player will play back audio to the selected zone(s).
NOTE: By default, media players 1 - 8 route the audio signals to their
respectively numbered speaker zones 1 - 8. If the user has not
specified the speaker zone when Spotify streaming begins, the
media player will automatically route to its default speaker zone.
For example, the audio from the media player 5 will be routed to
speaker zone 5.
to learn how.
DM NAX™ Product Manual (Doc.
After the Spotify streaming begins, you will be able to control the
volume of the streaming DM-NAX-8ZSA speaker zones directly from
your device.
Reset
A network reset or factory restore may be performed when
troubleshooting.
Network Reset
l
1. Ensure the device is powered on.
2. Press and hold the SETUP button for up to 15 seconds until the
SETUP LED flashes red.
The device will reboot, and the default network settings will be
reset, such as default Hostname, DHCP enabled, no static IP.
Factory Restore
l
1. Turn off the device by disconnecting the power cable from the
device.
2. Press and hold the SETUP button and then reconnect the power
cable while still holding the SETUP button. Continue holding the
SETUP button for up to 30 seconds until the SETUP LED flashes.
The device will reboot, and all the factory default settings will be
restored, such as Zone settings, names, multicast addressing, etc.
CAUTION: Performing a factory restore will clear all settings
from the device configuration.
Quick Start
8