Technical Specifications - Gemini 822 Series Installation And Use Manual

15.0 - DELETING PROGRAMMED DEVICES
To carry out the operation successfully, make sure the required electrical connections
!
(door/bonnet switches and ignition) are complete.
Any previously programmed device can be deleted as follows:
!
With the system disarmed, open the driver door and the bonnet and leave them open
The following operations must be carried out within 4 seconds otherwise the
!
!
Turn ignition key "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON".
!
At the fourth turn, leave it "ON".
!
To confirm it has entered in delete mode, the system gives 2 acoustic signals (1 Beep and1 Boop),
the turn indicators flash once and the status LED turns ON
!
Close the bonnet.
!
Keep the bonnet closed (approx. 8 sec.) until the devices are completely deleted
If the bonnet is opened before 8 seconds, the devices will not be
!
!
The status LED turns OFF when the devices have been deleted
!
Turn ignition key "OFF ".
!
The end of the procedure is confirmed by a long low-pitched acoustic signal.
PAGE 14 - INSTALLER MANUAL
procedure is invalidated.
.
.
deleted.
.
With this procedure all settings will be returned to the factory default settings.
!
Reset must therefore only be carried out in case of need, before programming the
To reset the system proceed as follows:
.
!
Disconnect the alarm power supply
!
S hort-circuit the RED and BLACK wires of the 2-pin
!
Power the system
!
Remove the previously created short-circuit; the status LED will light up steady.
!
Turn ignition key "ON";
approx. 3 seconds
!
Turn ignition key "OFF";
Current absorption @ 12Vdc with system armed and LED flashing
Maximum positive current output when armed (+A)
16.0 - SYSTEM RESET
system or learning the turn indicator flashes.
.
LED connector
; 4 acoustic signals and 4 flashes of the turn indicators will confirm the operation
reset is confirmed by 1 aucoustic signal and the wailing of the siren for
.
the LED will turn OFF. There are no acoustic signals

17.0 - TECHNICAL SPECIFICATIONS

Power supply 823 - 822
Working temperature range
Turn indicators relay contact capacity
Engine immobiliser relay contact capacity
Alarm cycle duration
Additional siren output current capacity
.
.
.
12 Vdc
15mA
From -30°C to +70°C
8 A @ 20°C
8 A @ 20°C
30 sec.
700 mA
1 A
INSTALLER MANUAL - PAGE 15