Gemini 822 Series Installation And Use Manual page 5

7.0 - CONNECTIONS TO ACTIVATE THE TURN INDICATORS
7.1 - STANDARD CONNECTIONS
LEFT TURN
INDICATORS
ORANGE
GEMINI 823
ORANGE
SYSTEM
WHITE-ORANGE
WHITE-ORANGE wire must ONLY be
connected if the system is to operate via
the turn indicators.
7.2 - CONNECTIONS FOR VEHICLES WITH SEPARATE LINES
WHITE-ORANGE wire must ONLY be
connected if the system is to operate via
turn indicators.
WHITE-ORANGE
ORANGE
GEMINI 823
SYSTEM
ORANGE
2 Amp. diodes.
7.3 - CONNECTION TO HAZARD SWITCH
GEMINI 823
SYSTEM
PAGE 08 - INSTALLER MANUAL
RIGHT TURN
INDICATORS
TURN INDICATORS
CONTROL UNIT
Front Side Rear Rear Side
LH LH LH RH RH
Add 6
Select "optical pulse signals"
in the "SYSTEM
PROGRAMMING" menu.
Do not make this connection
BLUE
if the system is to operate
via turn indicators.
VEHICLE
WIRING
CIRCUIT
8.0 - SELECTABLE CONNECTIONS TO ARM/DISARM THE SYSTEM
Power door locks must be connected according to vehicle type (see installation specifications). Check
out the various possibilities described below and proceed with the applicable connection.
!
Arming via door lock motors.
!
Arming via door lock motors and power door lock switches.
!
Arming via turn indicator flashes.
!
Arming via turn indicator flashes and door lock motors.
!
Arming via turn indicator flashes,
8.1 - CONNECTION TO DOOR LOCK MOTORS WITH SEPARATE RADIO RECEIVER
Arm/disarm connections for vehicles with a radio receiver that is separate from CDL (see www.gemini-
alarm.com for diagram "A" connection).
Set dip-switch N. 4 "ON".
8.2 - CONNECTION TO
Arm/disarm connections for vehicles that require not only connections to door lock motor unit but also
control of power door lock switch or of internal door lock buttons (see www.gemini-alarm.com for
diagram "C", "D", "E" connection).
Set dip-switch N. 4 "ON".
If the turn indicators lock/unlock flashes are identical, connect the door lock motors.
If the turn indicators flash when unlocking via the car mechanical key, do not make this
!
To arm/disarm via the
Front
RH • If arming/disarming is only activated via the turn indicators, set dip-switch N. 4 "OFF".
• If arming/disarming is activated via the turn indicators and door lock motor unit, set dip-switch N. 4 "ON".
In order to arm/disarm via the turn indicators, the system must learn the vehicle lock (arm) and unlock
(disarm) flashes.
Connect the WHITE-ORANGE wire to the turn indicators and proceed as follows
!
Disconnect the 8-pin harness connector from the 8-pin alarm connector
!
Turn ignition key
!
Connect the 8-pin harness connector to the 8-pin alarm connector; the LED will turn ON steady
!
T urn ignition key
!
When the turn indicators stop flashing, a Beep will confirm the learning of the arming flashes
!
Press the unlock button on the vehicle original remote control
!
When the turn indicators stop flashing, 2 Beeps will confirm the learning of the disarming flashes
!
At this point the learning procedure has been carried out
door lock motors and power lock switches
DOOR LOCK MOTORS WITH POWER DOOR
8.3 - CONNECTION TO TURN INDICATORS
connection.
turn indicator flashes, connect the WHITE-ORANGE wire to the turn indicators.
9.0 - LEARNING OF TURN INDICATOR FLASHES
"ON".
"OFF", c lose all doors and press the lock button on the original remote control
correctly
.
LOCK SWITCH
:
.
.
.
.
.
.
.
INSTALLER MANUAL - PAGE 09