Gemini 822 Series Installation And Use Manual page 7

12.0 - DIP-SWITCHES PROGRAMMING TABLE
Set dip-switches BEFORE connecting the alarm system.
!
If settings must be modified after installation, FIRST disconnect the alarm and then
N. POSITION
1 ON POSITIVE polarity for command on WHITE/LIGHT BLUE wire
1 OFF NEGATIVE polarity for command on WHITE/LIGHT BLUE wire
2 ON Positive signal (+A) on BROWN/RED with alarm armed
2 OFF
3 ON
3 OFF
Arming/disarming via door lock motors or motors and turn indicators
4 ON
4 OFF
With dip-switch N.2 set to "ON", the YELLOW-RED wire is grounded when the system is
!
armed. Leave dip-switch in this position when connecting only the WHITE-LIGHT BLUE
wire to the lock switch (grounded), with vehicle locked.
13.0 - ULTRASONIC VOLUMETRIC PROTECTION
13.1 - CONNECTIONS AND POSITIONING
Insert the WHITE connector in the "W" marked socket on the control unit.
Insert the RED connector in the "R" marked socket on the control unit.
Install the ultrasonic sensors on the top part of the windshield internal pillars, away from the air vents
and point them towards the center of the rear window
13.2 - SENSITIVITY ADJUSTMENT
T o check sensor sensitivity level proceed as follows
!
With the alarm system disarmed, roll down the front window approx. 20 cm.
!
Set the trimmer to an intermediate position (medium sensitivity).
!
Close all doors, bonnet and boot and arm the system.
!
During the arming delay, introduce an object in the cabin through the window and move it around;
the status LED will turn off to signal a presence.
!
If the sensitivity level is too high or too low, readjust the trimmer and repeat the above procedure
SENSITIVITY
ADJUSTMENT
PAGE 12 - INSTALLER MANUAL
reset the dip-switches.
FUNCTION
Standard operation
Negative input to arm/disarm the system
Positive input to arm/disarm the system
(See par. 8.0)
Arming/disarming via turn indicators only
.
:
ULTRASONIC
CONNECTIONS
To carry out the operation successfully, make sure the required electrical connections
!
!
If an extra device is added, it will automatically delete the first device programmed in the
Proceed as follows:
!
With the system disarmed, open the driver door and the bonnet and leave them open
The following operations must be carried out within 4 seconds otherwise the procedure
!
!
Turn ignition key "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON".
!
At the fourth turn, leave it "ON".
!
To confirm it has entered in learning mode, the system gives 2 acoustic signals (1 Beep and 1
Boop), the turn indicators flash once and the status LED turns ON
Do not close the bonnet otherwise all previously programmed devices will be erased
!
!
The system is ready to receive the device codes.
!
Insert the electronic key into its receptacle
!
Each time a device is learned a high-pitched signal sounds and the status LED turns OFF briefly
!
R epeat this procedure to program other devices.
!
Turn ignition key
!
T o confirm the end of the procedure, a low-pitched signal sounds, the turn indicators flash once and
the status LED turns OFF.
.
CELL
14.0 - ADDING NEW DEVICES
(door/bonnet switches and ignition) are complete.
Storing memory is for 55 devices
system memory
will be invalidated.
as described in the next paragraph.
.
"OFF".
.
.
.
.
.
INSTALLER MANUAL - PAGE 13