Proper Installation And Maintenance - Thermador Masterpiece VCI3B30ZS Installation Manual

Custom insert hoods
Hide thumbs Also See for Masterpiece VCI3B30ZS:
Table of Contents

Advertisement

Available languages

Available languages

I M P O R T A N T S A F E T Y I N S T R U C T I O N S
READ AND SAVE THESE INSTRUCTIONS

Proper installation and maintenance

WARNING
Remove all tape and packaging before using the appliance. Discard the
packaging after unpacking the appliance. Never allow children to play
with packaging material.
INSTALLER: Show the owner the location of the circuit breaker or fuse.
Mark it for easy reference.
This appliance must be properly installed and grounded by a qualifi ed
technician. Connect only to properly grounded outlet. Refer to
Installation Instructions for details.
This appliance is intended for normal family household use only. It is
not approved for outdoor use. If you have any questions, contact the
manufacturer.
Do not store or use corrosive chemicals, vapors, fl ammables or nonfood
products in or near this appliance. It is specifi cally designed for use when
heating or cooking food. The use of corrosive chemicals in heating or
cleaning will damage the appliance and could result in injury.
Do not operate this appliance if it is not working properly, or if it has
been damaged. Contact an authorized service provider.
Do not repair or replace any part of the appliance unless specifi cally
recommended in this manual. Refer all servicing to a factory authorized
service provider.
WARNING
Improper installation of gas appliances and ventilation hoods can create
a risk for carbon monoxide which can be harmful. To reduce the risk of
carbon monoxide poisoning, ensure the gas appliance is properly installed
according to the manufacturer's instructions, as well as ensuring the hood
is vented to the outside for proper exhausting of gases or fumes.
Refer to local building codes for latest requirements and restrictions when
installing ventilation products in recirculation
CAUTION
Grease left on fi lters can melt and move into the vent.
WARNING
Hidden surfaces may have sharp edges. Use caution when reaching
behind, in or under appliance.
mode.
WARNING
Two persons are recommended for the installation of this product.
WARNING
When the hood is operated in exhaust-air mode simultaneously with a
different appliance which also makes use of the same chimney (such as
gas, oil or coal-fi red heaters, continuous-fl ow heaters, hot-water boilers)
care must be taken to ensure that there is an adequate supply of fresh
air which will be needed by the appliance for combustion.
This can be achieved if combustion air can fl ow through non-lockable
openings, e.g. in doors, windows and via the air-intake/exhaust-air wall
box or by other technical measures, such as reciprocal interlocking, etc.
WARNING
Make-Up Air: Local building codes may require the use of make-up air
systems when using ducted ventilation systems greater than specifi ed CFM
of air movement. The specifi ed CFM varies from locale to locale. Consult
your HVAC professional for specifi c requirements in your area
Note: When assessing the overall requirement, the combined
ventilation system for the entire household must be taken into
consideration. This rule does not apply to the use of cooking
appliances, such as cooktops and ovens.
WARNING
To avoid electrical shock hazard, before installing, switch power off at
the service panel and lock the panel to prevent the power from being
switched on accidentally. Requirement: 120 VAC, 60 Hz, 15 A.
WARNING
Automatically operated device.
To reduce the risk of injury disconnect from power supply before
servicing.
Grounding instructions
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current.
Be sure your appliance is properly installed and grounded by a qualifi ed
technician. Installation, electrical connections and grounding must
comply with all applicable codes.
If required by the National Electrical Code (or Canadian Electrical
Code), this appliance must be installed on a separate branch circuit.
Safety codes and standards
This appliance complies with one or more of the following
Standards:
• UL 507, The Standard for the Safety of Electric Fans
• CSA C22.2 No. 113, Fans and Ventilators
It is the responsibility of the owner and the installer to determine if
additional requirements and/or standards apply to specifi c installations.
Page 5

Advertisement

Table of Contents
loading

Table of Contents