Install The Hood - Thermador Masterpiece VCI3B30ZS Installation Manual

I N S T A L L A T I O N

Install the hood

1. Run house power cable between service panel and hood location. Leave
a 3-foot length of power cable inside the cabinet. Attach the power
cable to the hood using the strain relief previously installed.
NOTE: The blower outlet should be towards the back/rear of the cabinet
and junction box should be on the right-hand side.
2. Insert the hood in the cabinet; both springs on each side will click. Make
sure all springs have clipped before releasing the unit.
Page 12
3. Lift the hood until contact is made between installation brackets and
cabinet is made (A). Secure the hood to the wood blocks previously
installed using (4) wood screws included in parts bag (2 screws per side)
(B). See illustration below.
B
4. Remove the 4 installation brackets (1 per unit corner). For each bracket,
remove the screw (A), then rotate the bracket to disengage it (B) from
the cabinet. Discard the brackets along with their screws according to
local laws and regulations.
A
A
B