Recirculating-Air Mode Fi Lter - Thermador Masterpiece VCI3B30ZS Installation Manual

I N S T A L L A T I O N
6. Assemble the remaining section of the electrical cover to the fi rst
section, by inserting its tab in the side slot (A) as shown below. Secure
this last section to the hood using the screw previously removed.
A
CAUTION
Ensure not to pinch wires when reinstalling the electrical
compartment cover.
7. Connect the blower to its connector inside the hood.
8. Reinstall the fi lter (A), then reinstall and close the decorative panel (B).
A
9. Turn on power supply at the service panel, then check the operation
of the hood (refer to the user manual).
Recirculating-air mode fi lter
To bind odors in recirculating-air mode, a charcoal fi lter must be installed.
The required charcoal fi lter kits are available for purchase from specialist
retailers, from customer service or from the Online Shop. See table below
to fi nd out the fi lter kit part number corresponding to the unit model.
Unit Model
VCI3B30ZS
VCI6B30ZS
VCI3B36ZS
VCI6B36ZS
Installing recirculating-air mode fi lter
1. Remove the grease fi lter from the hood. Install a charcoal fi lter
(included in the charcoal fi lter kit) on metal grease fi lter back (A).
Hold the charcoal fi lter in place using both metal clips (included in
the charcoal fi lter kit) (B).
A
Bottom view
B
Top view
2. Reinstall the grease fi lter.
B
Charcoal Filter Kit
CHFVCI30ZS
CHFVCI36ZS
Page 15