Table of Contents
Advertisement
Available languages
Available languages
Appliance Installation
44 CAUTION:
Vent unit to outside of building, only.
The hood can be mounted on a wall or suspended
from a cabinet. Both vertical and horizontal discharge
are possible with either mounting method.
Discharge Direction: The hood is shipped ready for
vertical discharge. To change to horizontal discharge
move the discharge cover shown in Figure ta to the
top of the hood. The plate is held in place by 4 (four)
Screws.
Assembly of the Transition:
The supplied
transition mounts to the top or rear of the hood
depending on the discharge direction.
1.
Align mounting holes at base of transition with
mounting holes on 1/2" flange located at the top
or rear of the hood depending on direction of
discharge.
2.
Fasten transition to hood using two (2) #8
sheetmetal screws (included with hood).
3.
Seal connection between transition and hood
with duct tape.
4.
Remove tape holding damper closed.
See Figure 1b for overall hood dimensions.
This opening is
xs
covered
for
horizontal
ig
discharge
|
This opening is
covered
for vertical
h
|
discharge.
Figure 1a: Discharge Direction
Figure 1b: Overall Dimensions
*Varies by model.
Advertisement
Table of Contents
