Table of Contents
Advertisement
4.0 Testing The Detector
Wait one minute after applying power and warm up time.
Conduct testing with the protected area cleared of all people.
Walk Test
1.
2. Set LED to ON position.
3. Reassemble the front cover.
4. Start walking slowly across the detection zone.
5. Observe that the LED lights whenever motion is detected.
6. Allow 5 sec. between each test for the detector to stabilise.
7.
NOTE:
Walk tests should be conducted, at least once a year, to verify proper operation of the
detector.
9
Remove front cover.
After the walk test is completed, you can set the LED to OFF position.
Advertisement
Table of Contents
