Table of Contents
Advertisement
QUICK START GUIDE
CAUTION
!
Turn off water supply and disconnect electrical
supply to unit prior to installation.
Use caution when handling back panel. The edges
could be sharp.
1.
Turn off water supply and disconnect electrical supply
USER GUIDE
to product prior to attempting installation.
USER GUIDE
2.
Remove the grille/access panel in the front and the
back panel.
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
3.
Locate water valve in the front of the unit and thread
3. Locate water
water supply line through.
valve in the front
3. Locate water
of the unit and
valve in the front
thread water
of the unit and
supply line
thread water
through.
supply line
through.
NOTICE
NOTICE
Route the water
supply line
Route the water
through the unit so it does not come into contact
supply line
NOTICE
with any internal components other than the
through the unit so it does not come into contact
solenoid valve. Normal operation creates some
with any internal components other than the
Route the water supply line through the unit
vibration. A water supply line contacting an
solenoid valve. Normal operation creates some
so it does not come into contact with any
internal component or cabinet wall can cause
vibration. A water supply line contacting an
internal components other than the solenoid
excessive noise during operation or damage to
internal component or cabinet wall can cause
valve. Normal operation creates some vibration.
the line.
excessive noise during operation or damage to
A water supply line contacting an internal
the line.
component or cabinet wall can cause excessive
noise during operation or damage to the line.
4. On the back panel,
break away filler feature
4. On the back panel,
4.
On the back panel, break away filler feature in bushing
in bushing with flat
break away filler feature
with a flat screwdriver.
screwdriver.
in bushing with flat
screwdriver.
5. Thread water line
through back panel hole
5. Thread water line
(with bushing) and
through back panel hole
connect to cold water
(with bushing) and
supply line.
connect to cold water
supply line.
break away filler feature
in bushing with flat
screwdriver.
5. Thread water line
through back panel hole
(with bushing) and
connect to cold water
supply line.
6. Turn on water supply and check for leaks.
7. Reinstall back panel and grille/front access panel.
8. Install retaining clip.
Remove
Remove
screwdriver
screwdriver
Remove
screwdriver
5.
Thread water line through back panel hole (with
bushing) and connect to cold water supply line.
6.
Turn on water supply and check for leaks.
7.
Reinstall back panel and grille/front access panel.
8.
Install retaining clip.
8. Install retaining clip.
8. Install retaining clip.
8
u-line.com
Remove
screwdriver
u-line.com
u-line.com
u-line.com
Advertisement
Table of Contents
