Table of Contents
Advertisement
USER GUIDE
QUICK START GUIDE
Interior Adjustments
1 CLASS REFRIGERATOR
INTERIOR SHELVES
Removing and Installing Interior
Shelves
For models equipped with glass shelves having recessed
shelf supports, remove the shelves as follows:
1. Pull shelf out about 6" (1), until back of shelf clears the
"hump" on the right-hand side.
2. Tilt up right-hand edge of shelf (2).
3. Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1. To move to a different position in the unit, insert shelf
at an angle, approximately 15-20°, over the rib in the
side of the unit where you want to place the shelf.
Place the shelf into the unit at an angle to clear the
door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door.
Lower the shelf and push it in completely. Ensure the
raised edge strip is toward the rear of the unit.
NOTICE
Make sure the shelves are inserted fully into the
unit.
The edge strip toward the rear prevents cans
and bottles from freezing against the cold
evaporator.
Interior Adjustments
3
1
2
USER GUIDE
5 Class Refrigerator
All 5 Class models feature side mounted rack supports
with 19 adjustment positions.
All refrigerators ship with 3 Slide and Secure storage bins.
Remove and reposition as desired.
Slide and Secure Storage Bin Removal
1.
Empty and remove bin.
2.
Firmly grasp both sides of storage bin frame and lift
front end slightly (about 1/4") to center the pin in the
slot.
3.
Pull frame towards you until all pins are clear of the
slots. If only repositioning the frame, do not remove
completely - go to "Storage Bin Installation" Step 2.
4.
Slightly tilt one side. Gently pull frame towards you to
remove from unit.
Note: Take care when removing frame to avoid
scratching interior of unit.
27
Interior Adjustments
u-line.com
u-line.com
Center
the pin
Advertisement
Table of Contents
