Table of Contents
Advertisement
Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transfer taste
QUICK START GUIDE
and/or odor to the interior products and damage or
discolor the interior.
CLEAR ICE MACHINE
CLEAR ICE MACHINE CLEANING CYCLE
Your U-Line clear ice machine has an automatic clean
alert function. Cleaning cycles should be run as notified.
USER GUIDE
Otherwise, to maintain operational efficiency the unit
should be cleaned every three months. Depending on
water conditions, more frequent cleaning may be
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
necessary. If the ice machine requires more frequent
cleaning, consult a plumber to test the water quality and
NOTICE
recommend appropriate treatment.
Use only U-Line Ice Machine Cleaner (Part No.
ULACLRCLEAN), available for purchase at
USER GUIDE
CAUTION
!
u-line.com or see your dealer. It is a violation
of federal law to use this solution in a manner
inconsistent with its labeling. Use of any other
Wear rubber gloves and safety goggles and/or
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
cleaner can ruin the finish of the evaporator
face shield when handling Ice Machine Cleaner.
and will void the warranty. Read and
NOTICE
understand all labels printed on the package
Use only U-Line Ice Machine Cleaner (Part No.
before use.
ULACLRCLEAN), available for purchase at
u-line.com or see your dealer. It is a violation
of federal law to use this solution in a manner
U-Line Ice Machine Cleaner is used to remove lime scale
inconsistent with its labeling. Use of any other
and other mineral deposits. Refer to the following steps to
cleaner can ruin the finish of the evaporator
initiate the self-cleaning cycle.
and will void the warranty. Read and
understand all labels printed on the package
before use.
CAUTION
!
Never use anything
U-Line Ice Machine Cleaner is used to remove lime scale
to force ice from the
and other mineral deposits. Refer to the following steps to
evaporator. Damage
initiate the self-cleaning cycle.
may result.
1. Turn the ice
CAUTION
!
machine off and
allow any ice to melt
Never use anything
off of the
to force ice from the
evaporator.
evaporator. Damage
may result.
2. Remove all ice from the storage bin.
1. Turn the ice
3. Remove evaporator cover.
machine off and
allow any ice to melt
off of the
4. Remove the standpipe by lifting it up while using a
evaporator.
slight back and forth motion to loosen it from the drain
hole. The water in the reservoir will flow down the
2. Remove all ice from the storage bin.
drain.
Cleaning 1
Evaporator cover
Evaporator cover
33
machine off and
allow any ice to melt
off of the
evaporator.
2. Remove all ice from the storage bin.
3. Remove evaporator cover.
4. Remove the standpipe by lifting it up while using a
slight back and forth motion to loosen it from the drain
hole. The water in the reservoir will flow down the
drain.
5. Re-install the standpipe into the water trough.
Evaporator
5. Re-install the standpipe into the water trough.
Standpipe
6. Clean the Interior Bin as follows:
Evaporator
• Dilute one packet of CLR cleaner into two quarts of
water.
• Using a sponge or cloth, clean interior of ice bin,
Standpipe
tubing and door. This cleaner will remove all mineral
6. Clean the Interior Bin as follows:
deposits and other contaminants from the surfaces.
• Dilute one packet of CLR cleaner into two quarts of
• Using a bottle brush, clean out the trough drain tube
water.
and pump tubing where needed.
• Using a sponge or cloth, clean interior of ice bin,
tubing and door. This cleaner will remove all mineral
deposits and other contaminants from the surfaces.
Brush
• Using a bottle brush, clean out the trough drain tube
and pump tubing where needed.
Brush
7. Turn unit on by pressing
8. Place the unit into CLEAN mode by holding
5 seconds.
u-line.com
u-line.com
u-line.com
Water trough
Water trough
.
for
7
8
Advertisement
Table of Contents
