BEFORE YOU START
INSTALLATION REQUIREMENTS
This heater MUST be installed ONLY by an authorised person.
The installation MUST conform to local regulations.
The installation MUST also comply with the instructions supplied by Rinnai.
Service and removal MUST be carried out ONLY by an authorised person.
CERTIFICATION
The Rinnai SS850 Gas Fire has been certified by the Australian Gas Association.
The AGA Certification Number is shown on the appliance data plate.
No parts or functions should be modified or permanently removed from the heater.
Please keep these instructions in a safe place for future reference.
CARTON CONTENTS / ITEM CHECKLIST
The following table lists the components for the Rinnai SS850 Gas Fires. Ensure that all the relevant components
for the model being installed are present before proceeding.
DO NOT Install any damaged items. Check all components have been supplied.
IMPORTANT
Major component descriptions and carton contents
➊
Rinnai SS850 Engine.
➋
Coaxial adapter.
➌
Colinear adapter.
➍
Zero clearance box.
➎
Masonry adapter frame.
➏
Four sided fascia.
Aeration plate and screws. Two are factory fitted on the engine, two are
➐
supplied in the accessory pack.
➑
Semi rigid stainless steel gas pipe with 5/8" connections (x1).
➒
½" BSP - 5/8" UNF flared brass adaptors (x1).
➓
Ceramic log set and granules.
Remote Control, Infra Red (IR).
11
Operation and Installation manual.
12
Rinnai
4
2
5
3
8
6
9
7
SS850ICLN (NG)
SS850ICLL (LPG)
N/A
N/A
6
10
11
12
SS850ICAN (NG)
SS850ICAL (LPG)
N/A
N/A
SS850 IM