Panasonic CT-24SL14J Service Manual page 175

NOTE
Screw configuration, type, and number of screws vary depending on the model of the receiver
serviced and the application; variou's models are covered in this manual. Use same hardware
when reassembling the receiver.
- 3 screws at the top edge of the receiver (for 25" sets).
- 2 screws at the top edge of the receiver (for 20" sets).
- 1 screw by the A/V jacks.
- 1 screw at each lower corner of the receiver.
- 1 screw by the Flyback.
A-Board - Main chassis
1. Slide the chassis completely out of the guide rails.
2. Stand the receiver on its edge. The underside of the board is
completely accessible for component replacement.
Note:
Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
C-Board - CRT output
The board plugs onto the socket on the CRT neck. To release the Focus wire, use a dull object to
release the tab on the socket (near the wire opening) and carefully pull on the wire. To connect
the focus wire, press on the tab to lock it then insertthe wire in the opening and press on it until it
is fully inserted and locked in place.
Focus cable release
Speakers
Each speaker is secured to the cabinet with 4 screws.
14