Panasonic CT-24SL14J Service Manual page 106

case)
- Increase "V-S" DATA by one step
NOTE
Repeat "a" and "b" until b-a ± 1.5mm
3. Confirm to make outermost circle of monoscope pattern a correct
circle
12.7. MTS circuit adjustments
The MTS circuit adjustments require two steps:
1. Input level adjustment.
2. Stereo separation adjustment.
Input level adjustment / Service DAC adjustment (MTSIN)
PREPARATION
1. Connect an RMS meter with filter jig as shown in figure to TPE11.
2. Connect an RF signal generator to the RF antenna input.
PROCEDURE
V-Adjustment
Filter Jig
31