Table of Contents
Advertisement
Heading
Option
Advanced*
Device options
(continued)
PCI VGA
Configuration
* Available on select models.
**These options should be used by advanced users only.
Service Reference Guide, dc5000
Allows you to set:
Printer mode (bi-directional, EPP+ECP, output only).
Num Lock state at power-on (off/on).
S5 Wake on LAN (enable/disable).
Processor cache (enable/disable).
Hyper-Threading* (enable/disable).
ACPI S3* support (enable/disable). S3 is an ACPI sleep state
that some add-in hardware options may not support.
✎
If the ACPI S3 support option is not presented, the other ACPI
S3 options (ACPI S3 Video REPOST, AXPI S3 Hard Disk
Reset, and ACPI S3 PS2 Mouse Wakeup) will not be
available.
ACPI S3 Video REPOST* (enable/disable). This feature reruns
the video option ROM on a boot from the S3 state.
ACPI S3 Hard Disk Reset* (enable/disable). Resets the hard
disk on a boot from the S3 sleep state.
ACPI S3 PS2 Mouse Wakeup* (enable/disable). Allows the
mouse to wake the system from the S3 sleep state.
Unique Sleep State Blink Patterns*. Allows you to choose an
LED blink pattern that uniquely identifies each sleep state.
Frame Buffer Size* Allows you to specify amount of system
memory dedicated to the embedded graphics frame buffer. The
AUTO setting attempts to optimize the frame buffer size
depending on the amount of total system memory.
Monitor Tracking (enable/disable). Allows ROM to save
monitor asset information.
Spread Spectrum* (enable/disable) allows system clocks to run
with a spread spectrum.
NIC PXE Option ROM Download (enable/disable). The BIOS
contains an embedded NIC option ROM to allow the unit to
boot through the network to a PXE server. This is typically used
to download a corporate image to a hard drive. The NIC
option ROM takes up memory space below 1MB commonly
referred to as DOS Compatibility Hole (DCH) space. This
space is limited. This F10 option will allow users to disable the
downloading of this embedded NIC option ROM thus giving
more DCH space for additional PCI cards which may need
option ROM space. The default will be to have the NIC option
ROM enabled.
Displayed only if there are multiple PCI video adapters in the
system. Allows you to specify which VGA controller will be the
"boot" or primary VGA controller.
360201-002
Setup Utilities and Diagnostics Features
Description
2–11
Advertisement
Table of Contents
