HP Compaq dc5000 MT Reference Manual page 137

Business desktop
Hide thumbs Also See for Compaq dc5000 MT:
Table of Contents

Advertisement

POST Error Messages
Screen Message
660-Display Cache is
Detected Unreliable
912-Computer Cover
Has Been Removed
Since Last System Start
Up
914-Hood Lock Coil is
not Connected
917-Expansion Riser
not Detected
919-Front Panel and/or
MultiPort Risers not
Detected.
1151-Serial Port 1
Address Conflict
Detected
1152-Serial Port 2
Address Conflict
Detected
1155-Serial Port
Address Conflict
Detected
1156-Serial Port A
Cable Not Detected
1157-Front Cables Not
Detected
Service Reference Guide, dc5000
Probable Cause
Integrated video
controller display cache
not working properly and
will be disabled.
Smart Cover lock
mechanism is missing or
not connected.
Riser board not seated or
not installed.
Riser card has been
removed or has not been
reinstalled properly in the
system.
Both external and internal
serial ports are assigned
to COM1.
Both external and internal
serial ports are assigned
to COM2.
Both external and internal
serial ports are assigned
to same IRQ.
Serial Port cable
assembly disconnected
from system board.
Front cable assembly
(audio and USB)
disconnected from the
system board.
360201-002
POST Error Messages
Recommended Action
Replace system board if minimal video
degrading is an issue.
No action required.
Reconnect or replace hood locking
mechanism.
Reseat or replace hood locking
mechanism cable.
Install riser board if missing or remove
and reseat to ensure good connection.
Unplug computer and install/reinstall
riser cord.
Remove any Comm port expansion
cards.
Clear CMOS.
Reconfigure card resources and/or run
Computer Setup (F10 Setup). Run
Computer Setup or Windows utilities.
Remove any Comm port expansion
cards.
Clear CMOS.
Reconfigure card resources and/or run
Computer Setup (F10 Setup). Run
Computer Setup or Windows utilities.
Remove any Comm port expansion
cards.
Clear CMOS.
Reconfigure card resources and/or run
Computer Setup (F10 Setup).Run
Computer Setup or Windows utilities.
Turn off unit, disconnect the power cable
from the power source, open the
computer chassis and attach serial port
cable to the system board.
Turn off unit, disconnect the power cable
from the power source, open the
computer chassis and attach front cable
assembly to the system board.
C–5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dc5000 - microtower pcCompaq dc5000 series

Table of Contents