Table of Contents
Advertisement
POST Error Messages
POST Error Messages
Screen Message
1201-System Audio
Address Conflict
Detected
1202-MIDI Port Address
Conflict Detected
1203-Game Port
Address Conflict
Detected
1720 SMART Hard
Drive Detect Imminent
Failure
1800-Temperature Alert
1801-Microcode Patch
Error
1998-Master Boot
Record has been lost.
1998-Master Boot
Record has been
changed.
2000-Master Boot
Record Hard Drive has
Changed.
C–6
Probable Cause
Device IRQ address
conflicts with another
device.
Device IRQ address
conflicts with another
device.
Device IRQ address
conflicts with another
device.
Hard drive is about to
fail. (Some hard drives
have a firmware patch
that will fix an erroneous
error message.)
Internal temperature
exceeds specification.
Processor not supported
by ROM BIOS.
The previously saved
copy of the MBR has
been corrupted.
The current MBR does not
match the previously
saved copy of the MBR.
The current bootable hard
drive is not the same as
the one that was present
when MBR security was
enabled.
360201-002
Recommended Action
Reset the IRQ.
Reset the IRQ.
Reset the IRQ
Determine if hard drive is giving correct
error message. Run the Drive Protection
System text if applicable.
Apply firmware patch if applicable. (see
www.hp.com/support)
Back up contents and replace hard drive.
Check that computer air vents are not
blocked and cooling fan is running.
Verify processor speed selection.
Replace the processor.
Replace the system board.
Upgrade BIOS to proper version.
Run Computer Setup and save the MBR
of the current bootable disk.
Use extreme caution, The MBR may have
been updated due to normal disk
maintenance activities (disk manager,
fdisk, or format). Replacing the
previously saved MBR in such situations
can cause data loss. If certain that the
MBR change is unintentional and
undesired (e.g. due to a virus), run
Computer Setup and restore the
previously saved MBR copy. Otherwise,
run Computer Setup and either disable
MBR security or save the MBR of the
current bootable disk.
Run Computer Setup and either disable
MBR security or save the MBR of the
current bootable disk.
Service Reference Guide, dc5000
Advertisement
Table of Contents
